Pretraživanje
Prikaz rezultata 1-10 od 34
Explosive boiling of water films based on molecular dynamics simulations: Effects of film thickness and substrate temperature
(Elsevier, 2023)
This paper deals with investigations of mechanisms governing explosive boiling of water films on hot copper substrate with plain surface. The investigations are based on results of molecular dynamics (MD) simulations in ...
Erosion Wear Behavior of High Chromium Cast Irons
(Springer, 2023)
In this study, two high chromium cast irons
(HCCI) with different chromium content (15%Cr and
25%Cr), in as-cast and annealed conditions (heat-treated,
HT), were tested to determine the erosion wear behavior of
these ...
Effect of building direction and heat treatment on mechanical properties of Inconel 939 prepared by additive manufacturing
(Springer Nature, 2023)
This study investigated the effect of building direction (BD) and three-step heat treatment on the microstructure and mechanical properties of a nickel-based superalloy Inconel 939 produced by additive manufacturing (AM), ...
Increased hydraulic resistance in tubes of once-through boiler due to fouling: A case study of 650 MWe ligite fired unit
(Elsevier, 2023)
The analysis of pressure changes in water and steam flow along the entire once-through steam boiler tube system at the 650 MWe lignite fired Unit was carried out after the long operational period of almost 30 years without ...
The influence of material infill on ABS-X flexural strength
(Springer, 2023)
This paper contains a comparison of the flexural strength results of two different samples. Both samples were made using additive manufacturing, from ABS (acrylonitrile butadiene styrene) material with the inclusion of an ...
Impact of residual stress on integrity of the vessel for methanol storing
(Društvo za integritet i vek konstrukcija „Prof. dr Stojan Sedmak“, 2023)
The purpose of this paper is to present impact of the improper choice of the procedure for repairing of pressure vessel for methanol storage, which finally could leads even to its failure. Represented information are based ...
Application of Composite Construction and Demolition Debris in Heavy Metals Removal from Industrial Wastewater
(Thermal Science, 2023)
The utilization of construction and demolition debris in industrial wastewater treatment by sorption of Co2+ and Ni2+ ions was investigated. Selected waste composites are cost-effective and locally available, still their ...
Ductile-to-brittle transition of ferritic steels: A historical sketch and some recent trends
(Engineering Fracture Mechanics, 2023)
The phenomenon of ductile-to-brittle transition in ferritic steels has been a ubiquitous research challenge for the last 50 years. The characterization of this problem using the fracture mechanics concept, from the earliest ...
New types of protective coatings and development of test methods
(Structural integrity and life, 2023)
The paper presents the results of synthesis and charac-terisation of refractory coatings based on various fillers intended for the protection of metallic structures. Refractory fillers applied are based on mullite, cordierite, ...
INSPECTION OF DAMAGE AND RISK ANALYSIS OF CONTAINERS IN A COAL DRYING FACILITY IN EXPLOITATION
(Društvo za integritet i vek konstrukcija „Prof. dr Stojan Sedmak“, Institut za ispitivanje materijala (IMS), Beograd, 2023)
Risk analysis of containers in a coal drying facility was performed using the Failure Modes and Effects Analysis (FMEA) method in combination with the risk matrix. The selected exploitation period analysed for all vessels ...