Pretraživanje
Prikaz rezultata 11-20 od 101
Some subtleties concerning fluid flow and turbulence modeling in 4-valve engines
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2011)
In this paper some results concerning the structure and evolution of fluid flow pattern during induction and compression in 4- valve engines with tilted valves were presented. Results were obtained by dint of multidimensional ...
The influence of buffer layer on the properties of surface welded joint of high-carbon steel
(Institute of Metals and Technology, 2011)
Surface welding with buffer layer is often in use because of its well-known properties of plasticity, or ability to slow crack growth initiated. However, in modern surface welding technologies, buffer layer is rarely used. ...
The possibilities for measurement and characterization of diesel engine fine particles: A review
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2011)
This review paper considers possible instrumentation for diesel engine fine particles exhaust emission evaluation. The modern diesel engines have extremely low particles emission almost at the level of measurement error ...
Thermomechanical modelling the resistance welding of PbSb alloy
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2010)
The analytical modelling of the PbSb alloy resistance spot welding process has been developed on the basis of mathematical analysis of thermomechanical conservation laws. The numerical solution of partial differential ...
Prompt system redesign: Shifting to open source technology to satisfy user requirements
(ComSIS Consortium, 2010)
The paper describes a redesign project undertaken in a short period to adapt a software system to user needs. Additional goals of the project included a shift to Open Source software and the selection of technology to ...
Numerical and experimental strength analysis of fire-tube boiler construction
(Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek, 2011)
Norms, such as EN 12952-3 and EN 12953-3 handle the issues concerned with calculation of the pressurized boiler components, not however considering the influences of thermal strains that are often of vital importance for ...
Diagnostics of bucket wheel excavator discharge boom dynamic performance and its reconstruction
(Polish Academy of Sciences Branch Lublin, 2014)
The paper focuses on an investigation into the possible causes of the bad dynamic performance of bucket wheel excavator C7OOS (BWE) discharge boom in the Kolubara opencast mine, Serbia. A discharge boom load carrying ...
Structural life assessment of oil rig pipes made of api j55 steel by high frequency welding
(Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek, 2013)
Structural life of welded pipes made of API J55 steel by high-frequency (HF) welding has been evaluated. Experimental tests of base metal mechanical properties, including fatigue properties, were conducted on pipes after ...
Heat input effect of friction stir welding on aluminum alloy aa 6061-t6 welded joint
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2016)
The paper deals with the heat input and maximum temperature developed during friction stir welding with different parameters. Aluminum alloy (AA 6061-T6) has been used for experimental and numerical analysis. Experimental ...
Improving structure dynamic behaviour using a reanalysis procedures technique
(Univ Osijek, Tech Fac, Slavonski Brod, 2013)
The present paper deals with the problem of improving dynamic characteristics for a sub-structure of bucket wheel excavator. The procedure is concerned with the analysis of the distribution of potential and kinetic energy ...