Претраживање
Приказ резултата 21-30 од 86
The failure analysis of the star-separator of an aircraft cannon
(Pergamon-Elsevier Science Ltd, Oxford, 2014)
This paper analyzes the causes of fracture of the double pipe aerial cannon stellate starseparator, which occurred during the fighting plane mission. The linear finite element method (FEM) is used to determine the stresses ...
Effect of Al2O3 nanoparticles and strontium addition on structural, mechanical and tribological properties of Zn25Al3Si alloy
(Springer Heidelberg, Heidelberg, 2018)
Nanocomposites were synthesized via compocasting using Zn25Al3Si and Zn25Al3Si0.03Sr alloys as the matrices and nanoparticles of Al2O3 (1 wt%) as the reinforcement. Structure of the nanocomposites was examined, and their ...
Rapid evaluation of maintenance process using statistical process control and simulation
(Daaam International Vienna, Vienna, 2018)
There are successful and less successful maintenance systems (MS). As a dynamic category, the success of the maintenance function must be taken into consideration both for the present day and the future. This is the reason ...
Numerical analysis of a hypersonic turbulent and laminar flow using a commercial cfd solver
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
Computational fluid dynamics computations for two hypersonic flow cases using the commercial ANSYS FLUENT 16.2 CFD software were done. In this paper, an internal and external hypersonic flow cases were considered and ...
Experimental Investigation of the Efficiency of Heat Pump Drying System with Full Air Recirculation
(Wiley, Hoboken, 2017)
The paper presents results of an experimental investigation of convective drying of apples var. Idared, potatoes var. Desiree and bananas var. Grand Nein, in full recirculation laboratory-scale dryer. The experiments were ...
Numerical simulation of fatigue crack propagation in friction stir welded joint made of Al 2024-T351 alloy
(Pergamon-Elsevier Science Ltd, Oxford, 2015)
In this work, fatigue crack propagation in thin-walled aluminium alloy structure with two friction stir welded T joints has been simulated numerically. Crack propagation in stiffened part of the structure between two ...
The performance of pip-cascade controler in hvac system
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
Primitive controllers used in the early version for HVAC systems, like the on-off (Bang-Bang) controller, are inefficient, inaccurate, unstable, and suffer from high-level mechanical wear. On the other hand, other controllers ...
Impact of choice of stabilized hysteresis loop on the end result of investigation of high-strength low-alloy (hsla) steel on low cycle fatigue
(Faculty of Metallurgy, 2014)
High strength low-alloy steel under low cycle fatigue at a certain level of strain controlled achieve stabilized condition. During the fatigue loading stabilized hysteresis loop is determined, which typical cycle of ...
Determining the theoretical reliability function of thermal power system using simple and complex weibull distribution
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
The main subject of this paper is the representation of the probabilistic technique for thermal power system reliability assessment. Exploitation research of the reliability of the fossil fuel power plant system has defined ...
Thermomechanics of soft inelastics bodies with application to asphalt behavior
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
Thermomechanical behavior of hot mix asphalt (HMA) is considered. Its highly irregular microstructure is covered by the hierarchical approach. A brief survey of endochronic thermodynamics precedes constitutive consideration. ...