Pretraživanje
Prikaz rezultata 1-10 od 76
Two-dimensional numerical analysis of active flow control by steady blowing along foil suction side by different urans turbulence models
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
The effects of active separation control by steady blowing jets were investigated numerically on three different examples: subsonic flow past Aerospatiale A airfoil at 13 degrees angle-of-attack, transonic flow past NACA ...
Heat transfer enhancement through pcm thermal storage by use of copper fins
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2016)
Enhancement of heat transfer over a cylinder shaped thermal energy storage filled by paraffin E53 by use of longitudinal rectangular copper fins was analyzed. The thermo-physical features of the storage material are ...
Experimental and numerical study of temperature field during hard-facing of different carbon steels
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2020)
In this research the 3-D transient non-linear thermal analysis of the hard-facing process was performed by using the experimental testing and finite element method. Testing was done at three different carbon steels and the ...
Kinetic parameters identification of conductive enhanced hot air drying process of food waste
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2021)
The efficient utilization of waste from food industry is possible after thermal treatment of the material. This treatment should be economically feasible and compromise the energy efficient drying process. The main goal ...
Turbulence recognition in free convective flow by thermal-video post-processing in the case of a thermal power plant mill
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2021)
This paper presents a study of a free convection flow around the walls of a ventilation mill of the Thermal Power Plant "Kostolac B", Kostolac, Serbia. A combined method consists of thermography and software post-processing, ...
Energy performance of single family houses in Serbia analzsis of calculation procedures
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2019)
Energy certification of buildings in Serbia was introduced in 2011 and energy label depends on energy need for heating per unit floor area of heated space, calculated by the fully prescribed monthly quasi-steady-state ...
Influence of temperature on behavior of the interfacial crack between the two layers
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2010)
In this paper is considered a problem of the semi-infinite crack at the interface between the two elastic isotropic layers in conditions of the environmental temperature change. The energy release rate needed for the crack ...
Development of the heating system using geothermal energy
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2006)
The paper presents the results achieved by the project financed by Ministry of Science and Environmental Protection of Serbia during the period 2003-2005. The purpose of the project was determination methodology for designing ...
Hoop of the fan mill
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2000)
While passing through the fan mill beater wheel, coal particles are mutually ground both by collision and friction. Having left the beater-wheel, under the influence of transport fluid flow in the mill chamber spiral, the ...
Theoretical-experimental determining of cooling time (t8/5) in hard facing of steels for forging dies
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2010)
This paper investigates the accuracy of analytical, empirical, and numerical expressions, i. e. the most favourable methods for calculating the cooling time from 800 to 500°C (t8/5). The degree of accuracy of time t8/5 is ...