Pretraživanje
Prikaz rezultata 1-10 od 36
Two-dimensional numerical analysis of active flow control by steady blowing along foil suction side by different urans turbulence models
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
The effects of active separation control by steady blowing jets were investigated numerically on three different examples: subsonic flow past Aerospatiale A airfoil at 13 degrees angle-of-attack, transonic flow past NACA ...
Energy performance of single family houses in Serbia analzsis of calculation procedures
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2019)
Energy certification of buildings in Serbia was introduced in 2011 and energy label depends on energy need for heating per unit floor area of heated space, calculated by the fully prescribed monthly quasi-steady-state ...
Numerical analysis of a hypersonic turbulent and laminar flow using a commercial cfd solver
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
Computational fluid dynamics computations for two hypersonic flow cases using the commercial ANSYS FLUENT 16.2 CFD software were done. In this paper, an internal and external hypersonic flow cases were considered and ...
Boundary-layer transition detection by thermography and numerical method around bionic train model in wind tunnel test
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
Methods of diagnosing aerodynamic characteristics are constantly developing in order to conduct the precise and energy efficient wind tunnel testing of transport vehicles in the prototype design early stages. This is of a ...
Measurement of thermal emission during cutting of materials using abrasive water jet
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
This article deals with measurement of the thermal gradient on material during abrasive water jet cutting. The temperature was measured by thermocamera before the technological process started, during the abrasive water ...
Determining the theoretical reliability function of thermal power system using simple and complex weibull distribution
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
The main subject of this paper is the representation of the probabilistic technique for thermal power system reliability assessment. Exploitation research of the reliability of the fossil fuel power plant system has defined ...
Numerical simulation of tensile testing of pe 80 polymer specimens
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
The aim of this paper is to present the behaviour of specimens made of polyethylene material PE 80, subjected to tensile load until failure. Measurements of the temperature distribution have been done using the infrared ...
Techno-economic evaluation of residue exhaustion in batch rectification ethanol production plant
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
This paper presents the techno-economic optimization of batch plant for production of rectified alcohol based on the concentration of ethanol in residue. The aim of the analysis was to determine the extent to which it is ...
Integration of the energy efficiency into the local development strategies
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
Balanced Scorecards represent powerful management tool for describing, explaining, representing and implementing different business strategies. Being in use for more than two decades, this tool proved its applicability in ...
Importance of on-time decision making in energy sector based on perspectives case study new stavalj project
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
Expression "Development conditions and perspectives" became important for numerous analyses in various industrial and social areas. Several strategic documents and studies in last two decades analysed projects with topics ...