Претраживање
Приказ резултата 41-50 од 54
Aerodynamic characteristics of low reynolds number airfoils
(Univ Osijek, Tech Fac, Slavonski Brod, 2017)
Assessment of airfoil aerodynamic characteristics is essential part of any optimal airfoil design procedure. This paper illustrates rapid and efficient method for determination of aerodynamic characteristics of an airfoil, ...
Compatibility of fracture mechanics parameters and fatigue crack growth parameters in welded joint behaviour evaluation
(Strojarski Facultet, 2013)
Problem of fracture toughness, K-Ic, determination on a crack tip localized in a welded joint is set in principle, since fracture mechanics presumes homogeneous material, not only in a crack tip surrounding but on a distance ...
Experimental in-vitro bone cements disintegration with ultrasonic pulsating water jet for revision arthroplasty
(Strojarski Facultet, 2015)
The paper deals with the study of using the selective property of ultrasonic pulsating water jet for the disintegration of the interface created by bone cement between cemented femoral stem and trabecular bone tissue as a ...
Potential for improvement of comfort parameters in off-road vehicles of Serbian armed forces
(Strojarski Facultet, 2014)
The paper presents the comparative results of comfort parameter testing inside the cabin of Land Rover Defender off-road vehicles. The measurements were carried out on two vehicle models -110 GS Hard Top and 110 GS Soft ...
Numerical-experimental analysis of the foldable containers strength
(Univ Osijek, Tech Fac, Slavonski Brod, 2015)
This paper describes the numerical and the experimental methodology for analysis of plastic packaging strength characteristics that are representative of its strength in the real life. Numerical analysis was conducted by ...
Techno-economic analysis of heat exchangers with parallel helical tube coils
(Univ Osijek, Tech Fac, Slavonski Brod, 2014)
The paper deals with the investment and exploitation costs for shell and tube heat exchangers with parallel helical tube coils. The most common correlations for estimating prices of shell and tube heat exchangers found in ...
Analysis of the supporting structure of composite material tool machine using the finite element method
(Univ Osijek, Tech Fac, Slavonski Brod, 2015)
Machines aimed for different purposes must be designed taking into account specific shape, type of load and materials they are made of. Nowadays different design solutions can easily be examined by using the finite element ...
Data Driven Root Cause Analyses in Multistage Manufacturing Utilising Life Cycle Wide Product Information
(Univ Osijek, Tech Fac, Slavonski Brod, 2019)
Root cause analyses in multistage manufacturing represents inspiration for constant improvement of existing methodologies and implementation of new ones. Using quality information data from manufacturing stage and customer ...
Improving structure dynamic behaviour using a reanalysis procedures technique
(Univ Osijek, Tech Fac, Slavonski Brod, 2013)
The present paper deals with the problem of improving dynamic characteristics for a sub-structure of bucket wheel excavator. The procedure is concerned with the analysis of the distribution of potential and kinetic energy ...
Damage tolerance analysis of structural components under general load spectrum
(Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek, 2012)
In this investigation fatigue behaviour of damaged structural components under cyclic loads constant amplitude and load spectrum is considered. Primary attention of this investigation is the establishment of computation ...