Претраживање
Приказ резултата 21-30 од 87
Oxidation behavior during prolonged service of boiler tubes made of 2.25Cr1Mo and 12Cr1Mo0.3V heat resistance steels
(Elsevier Science Bv, Amsterdam, 2016)
During service of thermal power plant (TPP) units, different components are exposed to high temperature due to technological cycle of TPP unit. Service lifetimes of these components, especially boiler heating surfaces, may ...
Model analysis of complex structures - advantages of physical sub-scaled model testing and shortcomings in physical model production
(Elsevier Science Bv, Amsterdam, 2018)
The possibilities of testing real constructions strength are often limited, especially in case of large constructions. Testing on the model, instead of the actual construction, results in a great saving of money and time. ...
Development of numerical-experimental model of connecting lugs and application on the lugs calculation of container terminals
(Elsevier Science Bv, Amsterdam, 2018)
The present paper describes numerical and experimental methodology and development of the model for stress and deformation state analysis of the connecting lug of container terminals. Numerical analysis was conducted by ...
Experimental determination of brittle fracturing appearance during static indentation of materials based on stone
(Springer Heidelberg, 2017)
During micro cutting process, the presence of both ductile and brittle mode is observed. The appearance of one or the other, or the value of critical penetration depth, when transition is happening, depends on the material ...
Wear simulation of the polymer based composite sliding bearings by means of ansys
(Faculty of Engineering, University of Kragujevac, 2019)
Polymer based composite sliding bearings are increasingly applied in many industries, due to their economic (usually low cost of production) and technical (good tribological properties) benefits. In order to predict their ...
Heat transfer and lubrication of turboshaft motor-reducer
(Institute of Physics Publishing, 2018)
Turboshaft engines, as the rule, contains gear transmission unit - reducer and belong to the group of drive systems with the name motor-reducer. These are the compact and autonomous assemblies for various applications. In ...
Dynamic stability of high speed turboshaft engine with reducer
(Institute of Physics Publishing, 2018)
The dynamic behavior of machines which rotate at extreme high speeds is crucial for stable and long operation. In design process some dynamics calculation must be taken into account to avoid potential operation near resonance ...
The influence of illumination parameters on the performances of color sorting machines
(Scientific Proceedings XII International Congress "Machines, Technologies, Materials" 2015, 2015)
The color recorded in the image is not an inherent value of observed object, because it is also influenced by the illumination properties, as well as geometry and surfaces of neighboring objects. Numerous studies have ...
Hladna metalizacija
(Belgrade : Singidunum University, 2017)
Nanošenje zaštitnih prevlaka na mašinske delove nalazi sve širu i učestaliju
primenu u svim granama industrije. Osnovna funkcija zaštinih prevlaka je
produženje radnog veka mašinskih delova povećanjem otpornosti na ...
Fe and Ni coatings used for wear protection of blinds
(Belgrade : Scientific association for development and affirmation of new technologies, 2015)
In this paper are shown the current problems of thermal power plants and cost effective solutions. Theaim of the research includes exploring of repair welding procedures, metallization and new materials high withresistance ...