Pretraživanje
Prikaz rezultata 31-40 od 206
Theoretical-experimental determining of cooling time (t8/5) in hard facing of steels for forging dies
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2010)
This paper investigates the accuracy of analytical, empirical, and numerical expressions, i. e. the most favourable methods for calculating the cooling time from 800 to 500°C (t8/5). The degree of accuracy of time t8/5 is ...
Defining the memory function for tension and deformation of linear textile products on the basis of their rheological models
(Industria Textila, 2009)
Defining the memory function for tension and deformation of linear textile products on the basis of their rheological models On the basis of rheological models for yarn elongation, which have been set out for three different ...
Characterisation of High-Carbon Steel Surface Welded Layer
(Assoc Mechanical Engineers Technicians Slovenia, Ljubljana, 2010)
In this paper microstructural and mechanical properties of high-carbon steel surface welded layer obtained with self-shielded flux cored wire are presented in standard rails and crossings. The testing results of tensile ...
Energy efficiency of residential buildings in Serbia
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2010)
In this paper, presented is the stale-of-the-art of energy Efficiency of residential buildings in Serbia. Special attention is paid to energy efficiency in already existing buildings. The average energy consumption in ...
Reconstruction of the aero-mixture channels of the pulverized coal plant of the 100 MW power plant unit
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2011)
After the last revitalization of thermal power block of 100 MW in TPP 'Kostolac A', made in the year 2004, during the operation of the plant, pulverized coal deposition often occurred in horizontal sections of the aero-mixture ...
The effect of bowl-in-piston geometry layout on fluid flow pattern
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2011)
In this paper some results concerning the evolution of 3-D fluid flow pattern through all four strokes in combustion chambers with entirely different bowl-in-piston geometry layouts ranging from 'omega' to 'simple cylinder' ...
Determination of a Light Helicopter Flight Performance at the Preliminary Design Stage
(Strojniski Vestnik/Journal of Mechanical Engineering, 2010)
Promising solutions for the problem of the extensively time-consuming modern urban transportation has been found in the use of light and very light helicopters. This paper presents a part of the preliminary design methodology, ...
The possibilities for measurement and characterization of diesel engine fine particles: A review
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2011)
This review paper considers possible instrumentation for diesel engine fine particles exhaust emission evaluation. The modern diesel engines have extremely low particles emission almost at the level of measurement error ...
Computational and experimental investigation into subsonic flow around a finned ogive cylinder
(Transactions of Famena, 2012)
Experimental and numerical investigation into the flow around an ogive cylinder with fins (missile calibration model) was conducted for Mach 0.6 flow. The computational results were compared to the results of pressure-distribution ...
Thermohydraulic experimental design for the European Helium-Cooled-Pebble-Bed Test Blanket Module
(Elsevier Science Sa, Lausanne, 2008)
The peculiarities of the coolant flow in Helium-Cooled-Pebble-Bed Test Blanket Module (TBM) are (i) very intensive heating of the first wall from the plasma side and (ii) very complicated geometry of How domain consisting ...