Претраживање
Приказ резултата 11-20 од 57
NUMERICAL SIMULATION OF WET FLUE GAS DESULPHURIZATION IN WET SPRAY ABSORBER
(Društvo termičara Srbije, 2022)
A concise one-dimensional thermal-hydraulic two-fluid model is presented for the
numerical prediction of sulphur dioxide absorption from the flue gas onto drops of the waterlimestone
slurry in the vertical spray tower ...
Solution for consolidation and retrofitting a historical steel bridge
(Elsevier Science Bv, Amsterdam, 2022)
Sustainable development is a fundamental goal of the European Union and seeks to meet the needs of the present, without compromising the future. The rehabilitation of historic steel constructions and old steel bridges in ...
Some problems of xFEM modelling of surface crack growth in a turbine shaft
(Procedia Structural Integrity 23 European Conference on Fracture, 2022)
One of the major problems in numerical simulation of fatigue loading represents the generation of a finite element mesh, since the model with crack cannot use combinations of different types of mesh elements (such as HEX ...
Determination of ductile-to-brittle transition temperature of NIOMOL 490K steel welded joints
(Procedia Structural Integrity 23 European Conference on Fracture, 2022)
This paper is devoted to the ductile–brittle transition behavior of high strength low alloyed structural steel NIOMOL 490K. This steel grade is designed for welded pressure vessels exposed to dynamic loads, operating at ...
Development of an Analogical Model for Strain Monitoring of Welded Joint Regions During Uniaxial Tensile Testing
(32 n d Conference with international participation WELDING 2022, 2022)
The idea behind the idea of developing this method was to introduce reference points at important locations, such as the fusion line and heat-affected zones, the displacement of which would be monitored during the uniaxial ...
COMPARISON OF FRACTURE MECHANICS PARAMETERS DURING TESTING OF SENT SPECIMENS MADE BY DIFFERENT ADDITIVE PRODUCTION TECHNIQUE
(Innovation Center of Faculty of Mechanical Engineering, 2022)
How and in which field products made by additive technologies can be applied depends not only on the type
of material and manufacturing technique but also on the economic aspect. The most affordable materials and
techniques ...
Deviation measurement of SLS PA material regarding location and orientation of printing
(Serbian Ceramic Society, 2022)
SLS technology is widely used in several industries worldwide mainly due to its ability to
manufacture complex geometry components with less effort compared to conventional
methods. Such technology uses materials in ...
Determining fracture mechanics parameters using the digital image correlation method on cylindrical samples produced by different additive manufacturing techniques
(Faculty of Mechanical Engineering, Univ. of Belgrade, 2022)
This work presents the difference in the values of fracture mechanics parameters obtained by
testing of cylindrical specimens with a sharp notch, cut on the tip of a wider groove. The
samples were obtained using two ...
Residual life of a historic riveted steel bridge - engineering critical assessment approach
(Elsevier, 2022)
Sustainability has become an increasingly important component of requirements for the rehabilitation of bridge structures.
Responsible use of our limited natural resources is essential for future generations, so the whole ...
Heritological-philosophical ideas in the research of the renewable energy sources implementation
(10th International Conference on Renewable Electrical Power Sources, 2022)
Along with the development of renewable energy research, in recent years, develop and a modern energy paradigm in relation to various aspects of the application of these sources, or energy
transition. Philosophical aspects ...