Претраживање
Приказ резултата 11-20 од 82
Numerical Evaluation of the Elastic Properties of Carbon Fiber Reinforced Composite Material at Elevated and Lowered Temperatures
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2021)
The effect of elevated and lowered temperatures on the elastic properties of carbon fiber-epoxy composite material was studied using multi-phase unit cell (MPUC) numerical model. Evaluation of the elastic properties of ...
Analysis of SA 387 Gr. 91 welded joints crack resistance under static and impact load
(Elsevier Science Bv, Amsterdam, 2021)
This paper presents the results of experimental testing of crack resistance of specimens taken from a welded plate made of steel SA-387 Gr. 91, while taking into account different filler materials and welding procedures ...
Development and calculation of supporting structure for mining power equipment
(Institut za ispitivanje materijala, Beograd, 2021)
Development and calculation of the base supporting struc-ture used for mining equipment is the aim of the paper. The base structure is intended for the installation of electronic communication and power equipment and devices ...
Repair welding procedure and techno-economic analysis of burner pipe
(Institut za ispitivanje materijala, Beograd, 2021)
The selection of the electrode for repair welding is one of the activities needed before repairing machine parts. In this case, damages that have occurred in a burner pipe welded joint during manufacture or previous repair ...
Finite element analysis of spherical storage tank stress state
(Institut za ispitivanje materijala, Beograd, 2021)
In this paper, a spherical storage tank for the storage of liquefied petroleum gas is analysed. A design calculation of structural elements is performed according to valid standards and technical regulations. Seismic loads ...
Algorithm for defining quality of base material for repair welding
(Institut za ispitivanje materijala, Beograd, 2021)
The paper shows the comparison of different methodologies for defining the quality of base material due for repair welding as one of the basic and initial problems during the repair of damaged parts or machine equipment. ...
Impact of downtime pattern on mining machinery efficiency
(Institut za ispitivanje materijala, Beograd, 2021)
In this paper, problem of mining machinery efficiency is considered through impact of different types of downtimes. New methodology is suggested based on comparison impact of mechanical and technological mining machinery ...
Influence of second-phase particles on fracture behavior of PLA and advanced PLA-X material
(Elsevier Science Bv, Amsterdam, 2021)
Most widespread materials in Additive Manufacturing are PLA (PolyLactic Acid) and ABS (Acrylonitrile Butadiene Styrene), which are dissimilar materials in terms of printing abilities and mechanical properties. PLA material ...
Structural integrity analysis of a cracked pressure vessel
(Institut za ispitivanje materijala, Beograd, 2021)
Stress distribution, as obtained by finite element method (FEM), and corresponding fracture mechanics parameters, have been used for the integrity assessment of a pressure vessel. Once the stress distribution is known, the ...
Failure analysis and numerical simulation of slab carrying clamps
(Gruppo Italiano Frattura, Cassino, 2021)
The goal of this study was to determine the reasons for failure of slab carrying clamps which had occurred in one of the clamp support levers. Detailed fractography analysis revealed that there was a welded joint at the ...