Претраживање
Приказ резултата 11-20 од 70
Material Effects on Risk Assessment of Residual Life of Oil Drilling Rig Pipe
(Elsevier, Amsterdam, 2020)
Fracture mechanics parameters are used for numerical and analytical risk assessment of residual life of a cracked oil drilling rig welded pipe. Number of cycles to the critical crack length, obtained by direct integration ...
Rules of Risk Management - Case Study of Open Pit Mine
(Elsevier, Amsterdam, 2020)
The issue of human factor risk and rules and regulations in open pit mine is a main focus of this paper in order to develop predictive models of behavior of workers in relation to compliance with the procedures and rules. ...
Experimental and numerical study of temperature field during hard-facing of different carbon steels
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2020)
In this research the 3-D transient non-linear thermal analysis of the hard-facing process was performed by using the experimental testing and finite element method. Testing was done at three different carbon steels and the ...
FEM simulation of welded joint geometry influence on fatigue crack growth resistance
(Elsevier, Amsterdam, 2020)
Fatigue behaviour of welded joints is investigated, in terms of welded joint geometry and the fatigue crack position. It is based on previous work which involved numerical simulation of fatigue crack growth in a welded ...
True Stress-strain Curves for HSLA Steel Weldment - Iteration Procedure Based on DIC and FEM
(Elsevier, Amsterdam, 2020)
True stress-strain curves of HSLA steel welded joint regions were estimated by using numerical simulation of strains measured by DIC and special iteration procedure to match the results. Strains were measured at certain ...
Numerical Simulation of Fatigue Crack Growth in Titanium Alloy Orthopaedic Plates
(Univ Osijek, Tech Fac, Slavonski Brod, 2020)
Biomaterials intended for orthopaedic plates manufacturing have much higher mechanical properties relative to the bone itself and still there are many cases where those plates fracture in service, with fatigue as the main ...
Crack initiation and propagation resistance of hsla steel welded joint constituents
(Institut za ispitivanje materijala, Beograd, 2020)
The welded joint is heterogeneous in its microstructure, mechanical and geometrical properties, thus the stress field is affected by different factors as well as by residual stress. Therefore, special procedures are needed ...
Design Aspects of Hip Implant Made of Ti-6Al-4V Extra Low Interstitials Alloy
(Elsevier Science Bv, Amsterdam, 2020)
The main concerns in design of hip implants are fracture and fatigue related issues. In this paper, reverse engineering is used to redesign a hip implant produced by precision casting, using Ti6Al4V Extra Low Interstitials ...
Extended FEM analysis of fatigue crack growth in Ti-6Al-4V orthopaedic plates
(Elsevier, Amsterdam, 2020)
The extended finite element method (xFEM) was used to analyse fatigue crack growth in orthopaedic locking compression plates (LCP), made of Titanium alloy, Ti-6Al-4V, loaded in four-point bending. The optimal geometry was ...
Analytical vs Numerical Calculation of Fatigue Life for Different Welded Joint Regions
(Univ Osijek, Tech Fac, Slavonski Brod, 2020)
This research will show the analytical way of determining the remaining life of a welded joint with a fatigue crack initiated in its heat affected zone. The calculation will be divided into two stages, since the fatigue ...