Претраживање
Приказ резултата 61-66 од 66
The influence of the temperature and exploitation time on the behaviour of a welded joint subjected to variable and impact load
(International Conference on New Trends in Fatigue and Fracture, 2018)
This paper presents the analysis of the temperature and exploitation time influence on the resistant measure to brittle fracture of welded joint constituents of the new and exploited low-alloyed Cr-Mo steel A-387 Gr. B ...
The Effects of Exploitation Conditions and Welding on Crack Initiation and Propagation in a Starting Pressure Vessel
(International Conference on New Trends in Fatigue and Fracture, 2018)
Cracks and other defects that can occur in pressure vessel have been a significant practical problem for the integrity of such vessels for a very long time, and these defects can initiate and propagate due to various ...
Calculation of the Archard’s wear coefficient of the polymer-based composite sliding bearings
(KOD 2018 – The 10th International Conference on Machine And Industrial Design In Mechanical Engineering, 2018)
Comprehensive approach to weld repair on elements of power transmission – case study for hydro turbine shaft
(Proceedings of the The 4th IIW South – East European Welding Congress, October, 10-13, 2018, Belgrade, 2018)
Turbine and generator rotors and shafts undergo highstresses during regular working life and, from a safetyand operational aspect, are the most significantcomponents of a power generation system. Dependingon the appropriate ...
Accuracy of polymer electrolyte membrane (PEM) fuel cell reformer prototypes using FDM and SLA 3D printing technology in comparison with digital CAD model
(Faculty of Mechanical Engineering. Innovation Center, 2018)
The subject of this paper is the evaluation of accuracy of FDM and SLA 3D printing technologies, in
comparison with developed reformer polymer electrolyte membrane (PEM) fuel cell CAD model. 3D printing technologies allow ...
Strain measurement setup of compressively loaded mandible model with teeth and compensations
(Faculty of Mechanical Engineering. Innovation Center, 2018)
In this study, the setup for strain measurement of loaded mandible model with teeth and compensations is presented. During mastication, bite forces exert compressive loads on mandible and teeth. If compensations are present ...