Претраживање
Приказ резултата 21-30 од 38
Application of digital image correlation in dentistry
(Croatian Society of Mechanics, 2013)
Microstructures and mechanical properties of creep resistant steel for application at elevated temperatures
(Elsevier Sci Ltd, Oxford, 2013)
The subject of this paper is the microstructural and mechanical characterisation of regions of the heat-affected zone (HAZ) in steels containing 9-12% Cr that are used for operation at elevated temperatures. Tests were ...
Work optimization for rotary regenerative air preheater based on an increase of heat capacity of the matrix and reduction of leakage in seal clearances
(China International Conference Center for Science and Technology, 2013)
The paper shows a reconstruction of rotary regenerative air preheater in purpose of increase of it's energy efficiency. The increase of matrix heat capacity was examined with minimal modifications to geometry of heat ...
Aerodynamic design and analysis of a small-scale vertical axis wind turbine
(Korean Soc Mechanical Engineers, Seoul, 2013)
Small-scale vertical axis wind turbines are regarded today as an attractive source of green energy, still insufficiently implemented and tested. This paper presents a fast design methodology of such a VAWT, in terms of ...
Numerical investigation of processes in the lignite-fired furnace when simple gray gas and weighted sum of gray gases models are used
(Pergamon-Elsevier Science Ltd, Oxford, 2013)
Comparison of the numerical investigation results was carried out when the simple gray gas (SGG) and weighted sum of gray gases (WSGG) models are used to model the radiative properties of the gas phase inside the lignite ...
Nanoscale material characterization under the influence of aggressive agents by magnetic force microscopy and opto-magnetic spectroscopy
(Trans Tech Publications Ltd, 2013)
Magnetic Force Microscopy (MFM) and Opto-Magnetic Spectroscopy (OMS) were used to characterize HTCV stainless steel and aluminum. Both materials were immersed in 1.0M HCl and 1.0M CH3COOH solutions for two hours. From the ...
Optimal vibration control of smart composite beams with optimal size and location of piezoelectric sensing and actuation
(Sage Publications Ltd, London, 2013)
Control performances of smart structures depend on the size and location of the piezoelectric actuators and sensors as well as on the applied control algorithm. This article presents optimal vibration control of a thin-walled ...
Wind energy resource development in Ethiopia as an alternative energy future beyond the. dominant hydropower
(Pergamon-Elsevier Science Ltd, Oxford, 2013)
Over the centuries, energy has been supplied by wood, coal, oil and natural gas, as well as by uranium. All these energy sources are limited and create pollution problems. This has led countries to focus on a sustainable ...
An engineering procedure for air side performance evaluation of flat tube heat exchangers with louvered fins
(Springer, New York, 2013)
An accurate evaluation of possible air side heat transfer surface geometries is a prerequisite for optimal heat exchanger design. Aiming for practical engineering applicability a simplified and transparent analytical ...
Research into factors that influence the success of erp implementation in a Serbian production company
(Editura Stiintifica F. M. R., 2013)
This paper presents the research of implementing the ERP (Enterprise Resource Planning) in manufacturing companies. Identified the factors that influence the assessment of the success of ERP implementation in manufacturing ...