Претраживање
Приказ резултата 21-30 од 173
Energetic and environmental sustainability of sub-geothermal heat pump heating in Serbia
(Journal of Environmental Protection and Ecology, 2012)
Feasibility of low enthalpy geothermal waters incorporation in Serbian energy source structure has been investigated. Energy potential of ground waters of modest temperature levels is usually neglected since they can not ...
Characterisation of High-Carbon Steel Surface Welded Layer
(Assoc Mechanical Engineers Technicians Slovenia, Ljubljana, 2010)
In this paper microstructural and mechanical properties of high-carbon steel surface welded layer obtained with self-shielded flux cored wire are presented in standard rails and crossings. The testing results of tensile ...
Analysis of welded tensile plates with a surface notch in the weld metal and heat affected zone
(Pergamon-Elsevier Science Ltd, Oxford, 2010)
The behavior of the plates with a surface notch under tensile external loading is experimentally and numerically analyzed. The specimens were made of micro-alloyed steel NIO-MOL 490 K. welded by MAC (CO2) welding method. ...
Determination of a Light Helicopter Flight Performance at the Preliminary Design Stage
(Strojniski Vestnik/Journal of Mechanical Engineering, 2010)
Promising solutions for the problem of the extensively time-consuming modern urban transportation has been found in the use of light and very light helicopters. This paper presents a part of the preliminary design methodology, ...
A review of bottom-up building stock models for energy consumption in the residential sector
(Pergamon-Elsevier Science Ltd, Oxford, 2010)
Efficient and rational implementation of building stock CO(2) emission reduction strategies and policies requires the application of comprehensive building stock models that have the ability to: (a) estimate the baseline ...
Computational and experimental investigation into subsonic flow around a finned ogive cylinder
(Transactions of Famena, 2012)
Experimental and numerical investigation into the flow around an ogive cylinder with fins (missile calibration model) was conducted for Mach 0.6 flow. The computational results were compared to the results of pressure-distribution ...
Load-bearing steel structure diagnostics on bucket wheel excavator, for the purpose of failure prevention
(Pergamon-Elsevier Science Ltd, Oxford, 2011)
The appearance of cracks on load-bearing steel structure of compact, hydraulic bucket wheel excavator was a perennial problem. Unfavourable stress concentration, inadequate geometry and structure of materials, inadequate ...
Improvement of algorithm for numerical crack modelling
(Springernature, London, 2010)
For numerical simulation of crack modelling in fracture mechanics the eXtended finite element method (Xfem) has been recently accepted as a new powerful and efficiency methodology. In the paper we present the details of ...
Evaluation of the local tensile properties of austenite-ferrite welded joint
(Chemicke Listy, 2011)
Local mechanical properties (Yield Strength Re and Hardening Coefficient H') of austenite-ferrite welded joint has been evaluated by using finite element method to simulate the strain distributions obtained experimentally ...
Compressive strains and displacement in a partially dentate lower jaw rehabilitated with two different treatment modalities
(Wiley, Hoboken, 2012)
Background: Understanding of the biomechanical consequences of the stresses generated to the supporting bone during occlusal loading is significant for improving the design and clinical planning process in partial edentulism ...