Претраживање
Приказ резултата 31-40 од 45
Effect of Over-Pressure on Pipeline Structural Integrity
(Univ Osijek, Tech Fac, Slavonski Brod, 2019)
The effect of proof over-pressure on pipeline structural integrity using fracture mechanics parameters is analysed in the case of pipeline in Reversed Hydro Power Plant, made of High Strength Low Alloyed steel with 800 MPa ...
Possibility of Reducing the Overpressure of Shock Wave of Powder Gases around the Mortar
(Univ Osijek, Tech Fac, Slavonski Brod, 2018)
This paper resulted from the research of the overpressure of the shock wave of the powder gases, which occurs during firing of the mortar. Work encompasses modeling and computation of the overpressure field. Increasing ...
Possibilities of predicting the behaviour of ferrite-austenite welded joints in pressure equipment during exploitation
(Univ Osijek, Tech Fac, Slavonski Brod, 2017)
Exploitation safety of pressure equipment depends, among other factors, on the possibility of predicting the behaviour of each of its components during exploitation. If the safety of analysis is oriented towards materials ...
Numerical analysis of local and global buckling of a stiffened beam-column
(Univ Osijek, Tech Fac, Slavonski Brod, 2017)
The linear buckling phenomenon is obviously very important for stability of compressed supports. The determination of buckling resistance is an important characteristic of the design of steel structure. Besides, the presence ...
Aerodynamic characteristics of low reynolds number airfoils
(Univ Osijek, Tech Fac, Slavonski Brod, 2017)
Assessment of airfoil aerodynamic characteristics is essential part of any optimal airfoil design procedure. This paper illustrates rapid and efficient method for determination of aerodynamic characteristics of an airfoil, ...
Compatibility of fracture mechanics parameters and fatigue crack growth parameters in welded joint behaviour evaluation
(Strojarski Facultet, 2013)
Problem of fracture toughness, K-Ic, determination on a crack tip localized in a welded joint is set in principle, since fracture mechanics presumes homogeneous material, not only in a crack tip surrounding but on a distance ...
Experimental in-vitro bone cements disintegration with ultrasonic pulsating water jet for revision arthroplasty
(Strojarski Facultet, 2015)
The paper deals with the study of using the selective property of ultrasonic pulsating water jet for the disintegration of the interface created by bone cement between cemented femoral stem and trabecular bone tissue as a ...
Potential for improvement of comfort parameters in off-road vehicles of Serbian armed forces
(Strojarski Facultet, 2014)
The paper presents the comparative results of comfort parameter testing inside the cabin of Land Rover Defender off-road vehicles. The measurements were carried out on two vehicle models -110 GS Hard Top and 110 GS Soft ...
Numerical-experimental analysis of the foldable containers strength
(Univ Osijek, Tech Fac, Slavonski Brod, 2015)
This paper describes the numerical and the experimental methodology for analysis of plastic packaging strength characteristics that are representative of its strength in the real life. Numerical analysis was conducted by ...
Techno-economic analysis of heat exchangers with parallel helical tube coils
(Univ Osijek, Tech Fac, Slavonski Brod, 2014)
The paper deals with the investment and exploitation costs for shell and tube heat exchangers with parallel helical tube coils. The most common correlations for estimating prices of shell and tube heat exchangers found in ...