Претраживање
Приказ резултата 21-30 од 71
Experimental determination of J-integral at elevated temperatures
(17th European Conference on Fracture 2008: Multilevel Approach to Fracture of Materials, Components, 2008)
In past two decades, the development of 9-12% Cr creep-resistant steel for critical components in coal-fired power stations that can withstand higher temperatures and pressures has been intensified in order to increase ...
The effect of annealing temperatures and cooling rates on microstructure and mechanical properties of investment cast Ti-6Al-4V alloy
(Elsevier Sci Ltd, Oxford, 2006)
Production of investment castings of titanium alloys was considerably increased during last years due to the significant cost savings compared to complicated machined parts. However, the disadvantage of as-cast titanium ...
Structural integrity assessment by local approach to fracture
(Kluwer Academic Publishers, 2006)
Modelling of ductile fracture initiation in strength mismatched welded joint
(Pergamon-Elsevier Science Ltd, Oxford, 2008)
In this paper, the effect of strength mismatch and width of the welded joints oil the stress-strain distribution in the crack tip region has been discussed. The single-edge notched bend (SENB) specimens (precrack length ...
Evaluation of damage of steam pipeline steel using local approach to fracture
(American Society of Mechanical Engineers, Pressure Vessels and Piping Division (Publication) PVP, 2008)
In the paper, the level of damage of steam pipeline steel after about 100,000 hours at 540°C (1004 °F) under pressure of 42 bars (609 PSI) is analyzed. Material degradation is estimated using a combined experimental and ...
Welded penstock, produced of high-strength steel and application of fracture mechanics parameters to structural integrity assessment
(Springer, Dordrecht, 2008)
Application of high-strength steel for welded penstock increased the probability of crack-like defects and in welded joint. Structural integrity assessment procedure is presented and applied to welded penstock produced of ...
The austempering study of alloyed ductile iron
(Elsevier Sci Ltd, Oxford, 2006)
Austempered ductile iron (ADI) proved to be an excellent material as it possesses attractive properties: high strength, ductility and toughness are combined with good wear resistance and machinability. These properties can ...
A computer code for the prediction of mill gases and hot air distribution between burners' sections at the utility boiler
(Pergamon-Elsevier Science Ltd, Oxford, 2008)
One of the main tasks during the design or simulation and analyses of the utility steam boiler operation is the prediction of a distribution of mill gases and hot air flow rates between burners' sections. These are the ...
Ductile crack growth initiation in welded joints - Micromechanical approach
(Welding in the World, 2008)
The integrity of welded structures depends on the load-carrying capacities of their welded joints. Having in mind that welding process produces a large microstructural gradient through the weld, resulting in variation of ...
Defining the memory function for tension and deformation of linear textile products on the basis of their rheological models
(Industria Textila, 2009)
Defining the memory function for tension and deformation of linear textile products on the basis of their rheological models On the basis of rheological models for yarn elongation, which have been set out for three different ...