Претраживање
Приказ резултата 21-30 од 44
Set-up of a pre-test mock-up experiment in preparation for the HCPB Breeder Unit mock-up experimental campaign
(Elsevier Science Sa, Lausanne, 2013)
The complexity of the experimental set-up for testing a full-scaled Breeder Unit (BU) mock-up for the European Helium Cooled Pebble Bed Test Blanket Module (HCPB-TBM) has motivated to build a pre-test mock-up experiment ...
Experimental investigations of flow distribution in coolant system of Helium-Cooled-Pebble-Bed Test Blanket Module
(Elsevier Science Sa, Lausanne, 2016)
This paper deals with investigations of flow distribution in the coolant system of the Helium-Cooled Pebble -Bed Test Blanket Module (HCPB TBM) for ITER. The investigations have been performed by manufacturing and testing ...
Thermal-hydraulics of helium cooled First Wall channels and scoping investigations on performance improvement by application of ribs and mixing devices
(Elsevier Science Sa, Lausanne, 2016)
The first wall (FW) of DEMO is a component with high thermal loads. The cooling of the FW has to comply with the material's upper and lower temperature limits and requirements from stress assessment, like low temperature ...
Nonlinear Dynamics as a Tool in Selection of Working Conditions for Radial Ball Bearing
(Springer, 2020)
This paper contains elements of a comprehensive research devoted to the dynamic behavior of radial ball bearings in real working conditions. The general motivation for this topic comes from the requirements for high ...
Tie-rods of the bucket wheel excavator slewing superstructure: A study of the eye plate stress state
(Elsevier Sci Ltd, Oxford, 2020)
Tie-rods of the bucket wheel and counterweight booms are vital parts of the bucket wheel excavator slewing superstructure. This paper is dedicated to the problem of identifying the stress state of the critical cross-section ...
Analysis of the nominal load effects on gear load capacity using the finite-element method
(Sage Publications Ltd, London, 2010)
This research investigates the effects of the nominal load value on load distribution of simultaneously meshing gear teeth pairs, and on the involute gear load capacity. The research results presented in this article confirm ...
A Heat Conduction and Convection Analytical Benchmark for Adjoint Solution Verification of Computational Fluid Dynamics Codes Used in Reactor Design
(Amer Nuclear Soc, La Grange Pk, 2016)
This work presents a heat transport benchmark problem when modeling the steady-state radial conduction in a fuel rod coupled to the axial heat convection in a coolant surrounding the rod and flowing along it. This benchmark ...
Non destructive monitoring of cavitation erosion of cordierite based coatings
(Composites Part B: Engineering, 2016)
Coating materials are widely used in refractory lining to prevent different deleterious effects such are reactions on the mold-metal contact surface, abrasion from liquid metal or alloy, gasses, slags, and other materials ...
Management of forest unit “Debeljak Medenovac” as a model example in ecological and energy value estimation of wood biomass
(Faculty of Mechanical Engineering and Naval Architecture, Zagreb, 2014)
The research aimed at presenting an example on how biomass production could be managed,
ecologically and energy value of biomass calculated, how it can be used and under which
conditions as well as how is the quantity ...
The Influence of Modifying Methods on the Quality of Eutectic and Hypereutectic Silumine for Diesel Engine Pistons
(International Journal of Cast Metals Research, 2013)
The results of the investigation of the influence of different modifiers (sodium, phosphorus, antimony and strontium) on the quality of AlSi12CuMgNi and AlSi18CuMgNi alloys, which are used for the production of pistons, ...