Претраживање
Приказ резултата 11-20 од 121
Experimental determination of guy wire tension
(University of Belgrade, 2012)
A PIC32 based activevibration control ofsmart composite beams
(University of Belgrade, 2012)
Assessment of aircraft wing frequency characteristics
(University of Belgrade, 2012)
The influence of corrosion on stress concentration factor at shaft to flange radius
(Springer Netherlands, 2013)
This paper describes the influence of corrosion on stress concentration factor and crack initiation at shaft-flange transition section. The real turbine shaft failure case study is used for research. This case study and ...
Numerical simulation of fatigue crack growth in friction stir welded T joint made of Al 2024 T351 alloy
(Elsevier Science Bv, Amsterdam, 2016)
The Extended Finite Element Method (xFEM) has been applied to simulate fatigue crack growth in an AA2024-T351 T welded joint, 5 mm thick, made by friction stir welding. The ABAQUS and Morfeo software has been used. Tensile ...
Determining of elasticity modulus of fiberglas reinforced plastic grating using finite element method
(VDI Verein Deutscher Ingenieure, 2014)
Analysis of strain distribution in overmatching V groove weld using digital image correlation
(Elsevier Science Bv, Amsterdam, 2018)
Welded joints are treated as critical sites when constructing and calculating welded structures due to inhomogeneity and anisotropy of materials at the welded joint site. Because of the change in the geometry of the elements, ...
Work optimization for rotary regenerative air preheater based on an increase of heat capacity of the matrix and reduction of leakage in seal clearances
(China International Conference Center for Science and Technology, 2013)
The paper shows a reconstruction of rotary regenerative air preheater in purpose of increase of it's energy efficiency. The increase of matrix heat capacity was examined with minimal modifications to geometry of heat ...
Design and testing characteristics of thin stainless steel diaphragms
(Elsevier Science Bv, Amsterdam, 2018)
Metal membranes are defined as thin steel circular plates. The metal membranes are widely used in the measurement technique and they are constantly loaded over the entire surface. In case that a membrane is loaded with ...
Effects of welding technology on the occurrence of fracture in welded joints
(Elsevier Science Bv, Amsterdam, 2018)
Welded joints represent locations where failure is most likely to occur in welded structures. Welded joint failure depends on their vulnerability to crack initiation and growth. These factors are significantly influenced ...