Претраживање
Приказ резултата 1-10 од 75
Hydrogen embrittlement of low carbon structural steel
(Elsevier Science Bv, Amsterdam, 2014)
Hydrogen embrittlement (HE) of steels is extremely interesting topic in many industrial applications, while a predictive physical model still does not exist. A number of studies carried out in the world are unambiguous ...
Numerical simulation of fatigue crack growth in friction stir welded T joint made of Al 2024 T351 alloy
(Elsevier Science Bv, Amsterdam, 2016)
The Extended Finite Element Method (xFEM) has been applied to simulate fatigue crack growth in an AA2024-T351 T welded joint, 5 mm thick, made by friction stir welding. The ABAQUS and Morfeo software has been used. Tensile ...
Analysis of strain distribution in overmatching V groove weld using digital image correlation
(Elsevier Science Bv, Amsterdam, 2018)
Welded joints are treated as critical sites when constructing and calculating welded structures due to inhomogeneity and anisotropy of materials at the welded joint site. Because of the change in the geometry of the elements, ...
Design and testing characteristics of thin stainless steel diaphragms
(Elsevier Science Bv, Amsterdam, 2018)
Metal membranes are defined as thin steel circular plates. The metal membranes are widely used in the measurement technique and they are constantly loaded over the entire surface. In case that a membrane is loaded with ...
Effects of welding technology on the occurrence of fracture in welded joints
(Elsevier Science Bv, Amsterdam, 2018)
Welded joints represent locations where failure is most likely to occur in welded structures. Welded joint failure depends on their vulnerability to crack initiation and growth. These factors are significantly influenced ...
Oxidation behavior during prolonged service of boiler tubes made of 2.25Cr1Mo and 12Cr1Mo0.3V heat resistance steels
(Elsevier Science Bv, Amsterdam, 2016)
During service of thermal power plant (TPP) units, different components are exposed to high temperature due to technological cycle of TPP unit. Service lifetimes of these components, especially boiler heating surfaces, may ...
Model analysis of complex structures - advantages of physical sub-scaled model testing and shortcomings in physical model production
(Elsevier Science Bv, Amsterdam, 2018)
The possibilities of testing real constructions strength are often limited, especially in case of large constructions. Testing on the model, instead of the actual construction, results in a great saving of money and time. ...
Development of numerical-experimental model of connecting lugs and application on the lugs calculation of container terminals
(Elsevier Science Bv, Amsterdam, 2018)
The present paper describes numerical and experimental methodology and development of the model for stress and deformation state analysis of the connecting lug of container terminals. Numerical analysis was conducted by ...
Wear simulation of the polymer based composite sliding bearings by means of ansys
(Faculty of Engineering, University of Kragujevac, 2019)
Polymer based composite sliding bearings are increasingly applied in many industries, due to their economic (usually low cost of production) and technical (good tribological properties) benefits. In order to predict their ...
Weibull probability distribution for reactor steel 20MnMoNi55 cleavage fracture in transition temperature
(Elsevier, Amsterdam, 2020)
This paper presents the results and methods used for determining of fracture toughness of reactor steel, denoted as 20MnMoNi55, typically used for structures working at low temperatures, in transition temperature area. In ...