Претраживање
Приказ резултата 1-10 од 20
Computation Method in Failure Analysis of Mechanically Fastened Joints at Layered Composites
(Assoc Mechanical Engineers Technicians Slovenia, Ljubljana, 2012)
This paper considers a computation method in failure analysis of layered composites containing pin-loaded holes. The investigation is focused on developing a reliable computation procedure to analyze initial failure load ...
Improving structure dynamic behaviour using a reanalysis procedures technique
(Univ Osijek, Tech Fac, Slavonski Brod, 2013)
The present paper deals with the problem of improving dynamic characteristics for a sub-structure of bucket wheel excavator. The procedure is concerned with the analysis of the distribution of potential and kinetic energy ...
Process of generating of quality solution of the oil gear pump which is leading to effectively high performance product
(Technics Technologies Education Management, 2012)
The paper is presented the basis of a procedural character of the generating of new products like hydraulic units with high quality and performance. The oil gear pump is present in various hydraulic systems that can be ...
Stress Analysis of Hyperbaric Chambers of Different Geometries
(Trans Tech Publications Ltd, Stafa-Zurich, 2014)
Hyperbaric Oxygen Therapy (HBOT) is a method used to administer pure oxygen at a pressure which is greater than atmospheric pressure in order to increase the concentration of 02 in the tissues, blood and cells, and correct ...
Numerical-experimental analysis of the foldable containers strength
(Univ Osijek, Tech Fac, Slavonski Brod, 2015)
This paper describes the numerical and the experimental methodology for analysis of plastic packaging strength characteristics that are representative of its strength in the real life. Numerical analysis was conducted by ...
Development of numerical-experimental model of connecting lugs and application on the lugs calculation of container terminals
(Elsevier Science Bv, Amsterdam, 2018)
The present paper describes numerical and experimental methodology and development of the model for stress and deformation state analysis of the connecting lug of container terminals. Numerical analysis was conducted by ...
Tačka najvećeg napona na konturi kvadratnog otvora u ploči / Hot spot along corner curvature of rectangular plate opening
(Univerzitet u Beogradu - Mašinski fakultet, Beograd, 2019)
Koncentracija napona u uglu kvadratnog otvora u ploči je poznata činjenica. Najčešće se uzima da je najveća koncentracija napona u samom temenu ugla (na ugaonoj koordinati od 45 stepeni u slučaju kvadratnog otvora). ...
Fracture and fatigue behaviour of implants made of Ti alloys
(Elsevier B.V., 2019)
This paper presents an analysis of Ti alloys used in biomedical applications, such as artificial joint implants and fixation plates, from a fracture mechanics perspective, including fatigue crack initiation and propagation ...
Fatigue crack growth in a structure exposed to high temperature
(Pergamon-Elsevier Science Ltd, Oxford, 2021)
The exhaust nozzle, made of titanium, is the part of a jet engine where the final expansion of the hot gas from the turbine occurs and where the speed of the exhaust gas is further increased to create thrust. During the ...
Numerical-Experimental Determination of Stress and Deformation State in Connecting Lugs with the Effect of Contact Area Size
(Univ Osijek, Tech Fac, Slavonski Brod, 2019)
The present paper describes numerical and experimental methodology for the analysis of stress and deformation state in structural elements with geometrical discontinuities. The research is based on structural elements of ...