Претраживање
Приказ резултата 1-10 од 76
Measurement of thermal emission during cutting of materials using abrasive water jet
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
This article deals with measurement of the thermal gradient on material during abrasive water jet cutting. The temperature was measured by thermocamera before the technological process started, during the abrasive water ...
Boiling heat transfer modelling a review and future prospectus
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2019)
This paper reviews the current status of boiling heat transfer modelling, discusses the need for its improvement due to unresolved intriguing experimental findings and emergence of novel technical applications and outlines ...
Finite element modelling of creep process - steady state stresses and strains
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
Finite element modelling of steady state creep process has been described. Using an analogy of visco-plastic problem with a described procedure, the finite element method has been used to calculate steady state stresses ...
Boundary-layer transition detection by thermography and numerical method around bionic train model in wind tunnel test
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
Methods of diagnosing aerodynamic characteristics are constantly developing in order to conduct the precise and energy efficient wind tunnel testing of transport vehicles in the prototype design early stages. This is of a ...
Influence of material velocity on heat generation during linear welding stage of friction stir welding
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2016)
The heat generated during friction stir welding process depends on plastic deformation of the material and friction between the tool and the material. In this work, heat generation is analysed with respect to the material ...
Numerical simulation of tensile testing of pe 80 polymer specimens
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
The aim of this paper is to present the behaviour of specimens made of polyethylene material PE 80, subjected to tensile load until failure. Measurements of the temperature distribution have been done using the infrared ...
Importance of on-time decision making in energy sector based on perspectives case study new stavalj project
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
Expression "Development conditions and perspectives" became important for numerous analyses in various industrial and social areas. Several strategic documents and studies in last two decades analysed projects with topics ...
Heat transfer enhancement through pcm thermal storage by use of copper fins
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2016)
Enhancement of heat transfer over a cylinder shaped thermal energy storage filled by paraffin E53 by use of longitudinal rectangular copper fins was analyzed. The thermo-physical features of the storage material are ...
Two-dimensional numerical analysis of active flow control by steady blowing along foil suction side by different urans turbulence models
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
The effects of active separation control by steady blowing jets were investigated numerically on three different examples: subsonic flow past Aerospatiale A airfoil at 13 degrees angle-of-attack, transonic flow past NACA ...
Integration of the energy efficiency into the local development strategies
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
Balanced Scorecards represent powerful management tool for describing, explaining, representing and implementing different business strategies. Being in use for more than two decades, this tool proved its applicability in ...