Претраживање
Приказ резултата 1-10 од 108
Rapid evaluation of maintenance process using statistical process control and simulation
(Daaam International Vienna, Vienna, 2018)
There are successful and less successful maintenance systems (MS). As a dynamic category, the success of the maintenance function must be taken into consideration both for the present day and the future. This is the reason ...
Exploring innovative solutions for aged concrete utilization: treatment of liquid radioactive waste
(Springer, New York, 2018)
In this study, the applicability of waste concrete as a sorbent material for the liquid radioactive waste management was considered. The sample was properly characterized in terms of mineralogical and surface composition, ...
Measurement of thermal emission during cutting of materials using abrasive water jet
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
This article deals with measurement of the thermal gradient on material during abrasive water jet cutting. The temperature was measured by thermocamera before the technological process started, during the abrasive water ...
Boiling heat transfer modelling a review and future prospectus
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2019)
This paper reviews the current status of boiling heat transfer modelling, discusses the need for its improvement due to unresolved intriguing experimental findings and emergence of novel technical applications and outlines ...
Finite element modelling of creep process - steady state stresses and strains
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
Finite element modelling of steady state creep process has been described. Using an analogy of visco-plastic problem with a described procedure, the finite element method has been used to calculate steady state stresses ...
Boundary-layer transition detection by thermography and numerical method around bionic train model in wind tunnel test
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
Methods of diagnosing aerodynamic characteristics are constantly developing in order to conduct the precise and energy efficient wind tunnel testing of transport vehicles in the prototype design early stages. This is of a ...
Selection of the optimal hard facing (HF) technology of damaged forging dies based on cooling time t8/5
(Faculty of Metallurgy, 2016)
In exploitation, the forging dies are exposed to heating up to very high temperatures, variable loads: compressive, impact and shear. In this paper, the reparatory hard facing of the damaged forging dies is considered. The ...
Determining the crack acceptability in the welded joints of a wind loaded cylindrical steel shell structure
(Pergamon-Elsevier Science Ltd, Oxford, 2018)
Engineering critical assessment can be considered as a mandatory request in the civil engineering designing and manufacturing process. The paper is presenting the procedure for determination of crack acceptability based ...
Numerical simulation of tensile testing of pe 80 polymer specimens
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
The aim of this paper is to present the behaviour of specimens made of polyethylene material PE 80, subjected to tensile load until failure. Measurements of the temperature distribution have been done using the infrared ...
Importance of on-time decision making in energy sector based on perspectives case study new stavalj project
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
Expression "Development conditions and perspectives" became important for numerous analyses in various industrial and social areas. Several strategic documents and studies in last two decades analysed projects with topics ...