Претраживање
Приказ резултата 181-190 од 207
Analysis of the estimated remaining service life of gas rectification columns
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2021)
Gas rectification columns are process apparatuses which are very important part of each onshore plant. Sudden failure of these types of columns causes huge daily losses, while fluid leakage can be very dangerous for the ...
Damage tolerance analysis of structural components under general load spectrum
(Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek, 2012)
In this investigation fatigue behaviour of damaged structural components under cyclic loads constant amplitude and load spectrum is considered. Primary attention of this investigation is the establishment of computation ...
Assessing the forest management in the Novi Pazar region (Southwest Serbia)
(FRESENIUS ENVIRONMENTAL BULLETIN, 2022)
To address the question of weather stands are managed sustainably in the Novi Pazar region (Southwest Serbia), this study compares the quantity of standing wood biomass in the Debeljak-Medenovac unit at the beginning and ...
Contemporary Maintenance Management of Power Plant Life Exhaustion Components
(Technics Technologies Education Management, 2010)
Reliability centered maintenance (RCM) has a key role in the quality system of thermal power plants. Electricity production is definitely not only production of a product, but also becomes a customer service. Reliability ...
Numerical study of transient three-dimensional heat conduction problem with a moving heat source
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2011)
A numerical study of transient three-dimensional heat conduction problem with a moving source is presented. For numerical solution Douglas-Gunn alternating direction implicit method is applied and for the moving heat source ...
Synthesis of the new Lost Foam refractory coatings based on talc
(Journal of the Serbian Chemical Society, 2022)
This paper is focused on the preparation procedures, using a talc-based filler, to improve the rheologic properties of the lost foam refractory coatings. Talc, with grain size of 40 mm, was mechanically activated in a ...
The influence of material infill on ABS-X flexural strength
(Springer, 2023)
This paper contains a comparison of the flexural strength results of two different samples. Both samples were made using additive manufacturing, from ABS (acrylonitrile butadiene styrene) material with the inclusion of an ...
Influence of Mechanical Activation of a Cordierite –Based Filler on Sedimentation Stability of Lost Foam Refractory Coatings
(Science of Sintering, 2019)
For the development of the Lost Foam refractory coatings with controlled rheologic properties, the influence of the mechanical activation process on the cordierite-based filler's properties change was examined. First of ...
Deformation mechanisms in ti3al-nb alloy at elevated temperatures
(Institute of Metals and Technology, 2010)
Ti3Al-11Nb-1V (x/%) was made in a vacuum arc furnace. Hot-rolling was conducted at 1050 degrees C in a two-phase field of the alloy. Strain-rate jump tests were performed at T = 800-1100 degrees C and strain rates of 10(-6) ...
Mathematical modeling and experimental investigation of a composite beam failure - Case study
(London : Sage Publications Ltd, 2023)
Composite materials have been extensively employed in the aviation industry in recent years. The application of new materials enables significant weight savings with improved mechanical characteristics. This is also very ...