Претраживање
Приказ резултата 21-30 од 60
Determination of bond strength between the hard-faced (HF) layer and the base material (BM) of forging dies
(Faculty of Metallurgy, 2016)
This paper points out complex working conditions of forging dies, which are the most frequent causes of their damage, and proposes suitable hard-facing repair procedures. The shear strength between the hard-faced layer and ...
Best Practices of Biomass Energy Life Cycle Assessment and Possible Applications in Serbia
(Zagreb Univ, Fac Forestry, Zagreb, 2016)
This paper aims to highlight the advantages of using Life Cycle Assessment (or LCA) tool in energy sector for rational energy consumption, selection of green technologies and process optimization. Besides the definition ...
Numerical simulation of tensile testing of pe 80 polymer specimens
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
The aim of this paper is to present the behaviour of specimens made of polyethylene material PE 80, subjected to tensile load until failure. Measurements of the temperature distribution have been done using the infrared ...
Computation Method in Failure Analysis of Mechanically Fastened Joints at Layered Composites
(Assoc Mechanical Engineers Technicians Slovenia, Ljubljana, 2012)
This paper considers a computation method in failure analysis of layered composites containing pin-loaded holes. The investigation is focused on developing a reliable computation procedure to analyze initial failure load ...
Stabilizacija karakteristika gasnih odvodnika prenapona primenom jonizujućeg zračenja / Stabilization of gas-filled surge arrester's characteristics by use of ionizing radiation
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2012)
U radu se razmatra stabilizacija električnog pražnjenja u gasovima primenom spoljašnjeg jonizujućeg zračenja. Razmatrano je pražnjenje modela gasnog odvodnika prenapona u pasivnom i aktivnom radnom režimu. Korišćen je ...
Numerical Modeling of the Porosity Influence on the Elastic Properties of Sintered Materials
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
The effect of structural porosity on the elastic properties of sintered materials was studied using the new multi pore unit cell numerical model - MPUC. Comparison between proposed MPUC model and previously adopted two-phase ...
Diesel production by fast pyrolysis of miscanthus giganteus, well-to-pump analysis using the greet model
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2019)
In this paper "well-to-pump" environmental analysis of pyrolytic diesel from Miscanthus gigantheus is performed. The average annual yield of Miscanthus from III-V year of cultivation on 1 ha of chernozem soil in Serbia ...
Cavitation Wear of Basalt-Based Glass Ceramic
(MDPI, Basel, 2019)
This paper examines the possibility of using basalt-based glass ceramics for construction of structural parts of equipment in metallurgy and mining. An ultrasonic vibration method with a stationary sample pursuant to the ...
Experimental and numerical analysis of thermo-chemical erosion in gun steel
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2019)
Various factors of thermo-chemical erosion process in gun steel were analysed. The factors are mainly related to the thermal load of gun barrel inside surface, characteristics of barrel surface and chemical interactions ...
The Mechanisms of Cavitation Erosion of Raw and Sintered Basalt
(Međunarodni Institut za nauku o sinterovanju, Beograd, 2019)
The paper analyzes the morphology of cavitation damage of raw and sintered basalt samples. The experiment was conducted using the ultrasonic vibratory cavitation test method according to the ASTM G-32 standard. During the ...