Search
Now showing items 31-40 of 87
Influence of friction stir welding parameters on properties of 2024 t3 aluminium alloy joints
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
The aim of this work is to analyse the process of friction stir welding (FSW) of 3 mm thick aluminium plates made of high strength aluminium alloy - 2024 T3, as well as to assess the mechanical properties of the produced ...
Numerical analysis of temperature field during hardfacing process and comparison with experimental results
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
The three-dimensional transient nonlinear thermal analysis of the hard facing process is performed by using the finite element method. The simulations were executed on the open source Salome platform using the open source ...
Water deoxygenation using hollow fiber membrane module with nitrogen as inert gas
(Taylor & Francis Inc, Philadelphia, 2015)
A pilot plant scale fiber membrane system was developed for the removal of dissolved oxygen from water via nitrogen vacuum. Feed water was introduced to the shell side; a nitrogen gas was applied to the lumen side, as an ...
Identification of low cycle fatigue parameters of high strength low-alloy (hsla) steel at room temperature
(Croatian Metallurgical Soc, Zagreb, 2014)
Low cycle fatigue test was performed in ambient atmosphere at room temperature. cycle loading of material, in case of High strength low-alloy steel, entails modifications of its properties and in this paper is therefore ...
Stabilizacija karakteristika gasnih odvodnika prenapona primenom jonizujućeg zračenja / Stabilization of gas-filled surge arrester's characteristics by use of ionizing radiation
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2012)
U radu se razmatra stabilizacija električnog pražnjenja u gasovima primenom spoljašnjeg jonizujućeg zračenja. Razmatrano je pražnjenje modela gasnog odvodnika prenapona u pasivnom i aktivnom radnom režimu. Korišćen je ...
Failure analysis of hydraulic turbine shaft
(Pergamon-Elsevier Science Ltd, Oxford, 2012)
This paper describes the analysis of major failure of 28 MW horizontal hydro turbine shaft. The analysis of load carrying capacity of critical radius and fractography analysis are presented. Special emphasize is on ...
Computational fracture mechanics: An overview from early efforts to recent achievements
(Wiley, Hoboken, 2018)
An overview of the state of the art of computational fracture mechanics is presented, starting from early efforts and going all the way up to recent achievements. Some specific aspects of linear elastic and elastic plastic ...
Techno-economic evaluation of residue exhaustion in batch rectification ethanol production plant
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
This paper presents the techno-economic optimization of batch plant for production of rectified alcohol based on the concentration of ethanol in residue. The aim of the analysis was to determine the extent to which it is ...
Effect of aging on mechanical properties of Al-8Si-8Fe-1.4v/SiCp composites
(Faculty of Metallurgy, 2016)
In this study, Al-8Fe-8Si-1.4V/SiCp composites fabricated by squeeze casting process were age-hardened to Study the influence of heat treatment on mechanical properties, such as hardness, bending strength and modulus of ...
Two-dimensional numerical analysis of active flow control by steady blowing along foil suction side by different urans turbulence models
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
The effects of active separation control by steady blowing jets were investigated numerically on three different examples: subsonic flow past Aerospatiale A airfoil at 13 degrees angle-of-attack, transonic flow past NACA ...